Should you aerate before slice seeding

Slice seeding with a machine is the best way to over-seed an existing lawn. … This ensures soil to seed contact which is essential for adequate germination. The best results occur when core aeration is performed first. The soil must be moist for good penetration of the coring tines.

Should I aerate and slit seed?

Slice seeding is all about planting grass seed for the fastest, most thorough growth of new grass. Aeration addresses a deeper issue, literally — creating healthier soil to allow air, water and nutrients to penetrate the grassroots. … As your lawn continues to thrive, aerating every year or two.

When should you slice seed your lawn?

What About Timing? Both of these procedures are best done in the early fall, by the end of September. The cool, wet weather gives seeds the best chance to germinate before they have to deal with summer’s heat and drought. Then, when spring arrives, your lawn can focus all of its energy on growth.

Should I seed before or after aeration?

Within 48 hours after you aerate you should over seed, fertilize, and water your lawn. The seed, fertilizer, and water will have the best chance to get down into the holes made by the aerator if applied soon after aeration.

Should I slice seed in the spring?

Late spring is beneficial for aerating if the ground is extremely compacted or if there’s an abundance of thin grass. Later spring is best since weeds have established but before they flower. Slit Seeding. Slit seeding lawns is a technique of planting grass seeds that mix dethatching with seeding.

Can you aerate and seed at the same time?

Our Solution: Perform Them at The Same Time Aeration provides the perfect area for seeds to fall into and grow. The new grass seed will take the available water, oxygen, and nutrients and start to thrive, starving out potential weeds in the process.

Can I fertilize and seed at the same time?

When seeding a lawn, you should never apply the fertilizer and seed together. This can cause an uneven distribution of the materials resulting in patchy areas or seedlings burned by excess fertilizer. It is best to spread the fertilizer just prior to planting the seed.

Is an Overseeder the same as a slice seeder?

A slice seeder is perfect for lawns with more patchy growth and burnt grass as it has a higher germination rate. At the same time, the overseeder is ideal when trying to thicken a thin lawn as it does not need a very high germination rate, and it’ll also protect the good grasses.

Do I fertilize or overseed first?

Stop fertilizing for at least a month before overseeding. The fertilizer makes your grass grow faster, which makes it harder for the new seeds to take hold. Identify your grass type or the type of grass you want to grow, so you can manage it appropriately.

Is there a bad time to aerate your lawn?

You want to aerate the lawn when your grass is in its peak growing period so it can recover quickly—think early spring or fall for cool-season grasses, and late spring through early summer for warm-season grasses. If you have high-traffic areas or heavy clay soil, you will want to aerate every year.

Article first time published on

Can you mow after slice seeding?

Mowing Your Slice Seeded Lawn Wait two weeks after that initial mowing before mowing again. After that, just mow as you normally would.

What do Dethatchers do?

Simply put, a dethatcher is a device that effectively removes thatch from your lawn. A dethatcher can be as simple as a rake, towed behind your tractor, or even motorized for commercial jobs. A dethatcher uses metal blades or tines to comb across the grass and pull thatch up to the surface of the lawn.

Should I put fertilizer down with new grass seed?

The ideal time to fertilize new grass seed is before or while the seed is being sown. Although starter fertilizers vary slightly in composition, most have quick-release nitrogen, which gives the seeds the nutritional boost they need to promote healthy germination and to ensure rapid establishment.

What is the best fertilizer for new grass seed?

In summary, a lawn starter fertilizer high in phosphorus and quick-releasing nitrogen is ideal for starting a lawn from seed. Regular slow-release fertilizer that is rich in nitrogen is best for planting sod or giving your existing lawn a boost.

Can I use Scotts Turf Builder on new seed?

Whether you’re planting new grass, starting a new lawn, reseeding an existing one, or installing sod, sprigs or grass plugs, Scotts Turf Builder Starter Food for New Grass is safe to use on any grass type.

Should you dethatch before aerating?

Should I aerate or dethatch first? It is best to dethatch first before aerating your lawn. This way, you’ll remove the excess debris and promote healthy root development. Aerating is best done when there’s the problem of compaction.

How long after aeration can I mow?

After you lay down your seedlings, they’ll need time and the right environmental protection to grow. They’ll need to acclimate and set roots before the first mow, so during the first two to four weeks post aerating and overseeding, don’t mow.

Should I put topsoil over grass seed?

You don’t need to turn the topsoil over. Just break it up so the new grass seeds’ roots can easily grow through. If you just have a small area to seed, a digging fork will do the trick. For larger areas, consider a core aerator.

Should I pick up plugs after aerating?

Those aeration plugs are vital to the health of your lawn. Resist the urge to “clean” the lawn after it’s been aerated, and whatever you do, don’t remove the plugs.

Does overseeding actually work?

The effectiveness of overseeding, whether done in the spring or fall, is enhanced when it is combined with lawn aeration. … Overseeding lawns in spring can thicken lawns and make them more attractive, but it’s hardly just a matter of throwing the best grass seed onto the lawn.

Is aeration overseeding worth it?

The aeration gets rid of compacted soil and thatch, which means the roots can get everything they need to grow and overseeding ensures there is plenty of grass growing to cover the lawn and ensure it looks thick and green.

Which is better plug or spike aerator?

Plug aerators are usually more effective at relieving compaction in lawns with a heavy clay soil since the solid tines used on spike aerators compact the clay soil further when they push into the ground. … Soils that crumble easily are usually high in loam and sand which benefit more from the use of a spike aerator.

Should I slice seed?

While it’s effective, slice seeding is also one of the most intense lawn seeding methods for established lawns. If your lawn is in half decent shape, there’s really no need for something so intensive. In fact, a slice seeder will rip out existing plants and till up a lot of your existing healthy lawn.

Should I aerate before hydroseeding?

So before any seed goes down, your clay soil needs aeration. Aeration uses a machine to pull out tiny cores of soil from your lawn. These new holes allow water and oxygen to get to the roots, so they can grow nice and deep.

Can you aerate your lawn in November?

For warm-season grasses it is too late to aerate once the growing season has passed in late summer into early fall. For cool-season grasses, late fall into early winter is too late to aerate.

Should I mow lawn before aerating?

Before you aerate, mow your lawn low (Timberline lawn experts recommend setting your mower to about 1.5-2 inches above the ground to maximize the effectiveness of aerating, being sure to not scalp the crown of the grass.) You will want to water one to three days before aerating.

Is dethatching good for the lawn?

Lawn dethatching can be crucial to keeping your grass and soil healthy. Even if you are mowing and doing everything else necessary for your lawn, thatch can build up. … Detaching removes the thick layer of dead plant material (thatch). This allows air, water, and nutrients to reach your plants and soil again.

What do you do after slit seeding?

Have a soil test done. …
Decide on the type of grass seed you want. …
Mow your lawn. …
Rake the lawn (particularly if you don’t have a bagger on your mower). …
Apply fertilizer based on soil-test-recommendations.

How much seed do you use for a slice seeder?

Put half of your grass seed into the slit seeder’s hopper. Change the seeding application rate on the machine to half the recommended rate. Common recommended rates include 5 pounds per 1,000 square feet for fescues, 6 pounds for needlegrass and 2 pounds for bunchgrass.

How much seeds do you need to slit seeds?

The most common setting for the slit seeder is to lay about 5 pounds of seed per 1,000 square foot. Once set and ready walk the seeder from one end of the lot to the other in a straight line. What is this? Depending on the slit seeder it will place seed in the slits in rows around 4 inches apart.

Does dethatching aerate?

They both serve to help key nutrients like fertilizer, water or oxygen reach your lawn’s root zone so that your grass can continue to grow and thrive. However, aeration results in the breakdown of compacted soil whereas dethatching removes layers of thatch, or dead grass and other debris, from the top of the soil.